Nowadays, with the gradual development of technology, The automatic servo tube bending machine in our country is also in the hydraulic servo tube bending machine, automatic servo tube bending machine The quality and technology of pipe processing machinery such as machine, pipe cutting machine, pipe shrinking machine are increasingly mature and stable, and will not be in a state of exploration as in the past because of the birth of new products and new technologies, so the performance stability of the machine is relatively fragile, but the pipe processing equipment is stable and standardized, so after purchasing the machine tool, as long as you carefully maintain the machine tool, you can use it for a long time. Below Yonghang servo tube bending machine feed belt manufacturers tell you how to avoid servo tube bending machine failure!

In the daily use of servo tube bending machines, problems usually occur in the hydraulic area, because the machine is bent and the pipes are cut with a metal circular saw, leaving many small iron pins. If these iron pins are not cleaned, they will be taken directly to the servo tube bending machine for bending. Many servo tube bending machine molds have mandrel bending, which will cause wrinkles or collapse due to fear of insufficient fullness.

This way, when the servo tube bending machine inserts the pipe into the mandrel, these small iron pins fall out, and the uncleaned iron pins fall into the fuel tank inside the fuselage. It is well known that the hydraulic servo tube bending machine uses an oil pump to input hydraulic oil and provides hydraulic power through a solenoid valve. Therefore, after these iron pins enter the oil tank, most of them will be filtered out by the filter screen in the oil inlet tube, but there will also be a small part of the iron pins into the oil pump, so that the iron pins into the oil pump will enter the solenoid valve, and these iron pins can not flow in the solenoid valve and block the hydraulic solenoid valve, and the hydraulic oil can not flow, there will be corresponding action failures. The hydraulic servo tube bending machine can not work normally.

Even if this phenomenon occurs, there is no need to panic. Just press the button on the control panel, manually press an action, then look at the indicator light on the solenoid to see which solenoid doesn't work, and turn off the movie. Then use a 4mm hex wrench to remove the solenoid valve fixed on the oil distribution plate. After cleaning the solenoid valve with clean kerosene, blow it clean with an air gun, clean the iron pin inside, and then install.

servo tube bending machine https://www.john-sheng.com/All-Servo-Tube-Bender